3
290A Installation Instructions
Installing the housing
Recommendation:
Keep the housing closed when possible during the installation to prevent
the build-up of dust and moisture inside the housing.
Important:
This product should be installed by certified electrical technicians in compliance
with local laws and regulations.
Warning:
High voltage - the apparatus works on 100-240VAC. Always ensure that the
power is disconnected before starting any work or opening the housing.
No.
8. Housing
9. White rubber seal
10. Widget
11. Swivel
12. Bracket arm
13. Positioning bolt
9
8
1
12
10
11
13
.
1. Detach the bracket from the housing by unscrewing the positioning bolt (13). Use the
large allen key (1) to do this. Continue until the swivel (11) (still attached to the
housing) comes completely loose from the bracket arm (12). The positioning bolt (13)
is held in the bracket arm (12) by a plastic washer inside.
2. Detach the swivel (11) from the housing by loosening its four screws. Use the small
allen key (2) to do this. The four screws are held in the swivel (11) by plastic washers.
3. Position the bracket arm (12) on the wall in the position required and drill four
fixing indicators. Remove the bracket arm and drill the four holes (using an 11 mm
drill bit) to the depth and size (50 mm) of the plugs provided.
4. Route the cables through the rear of the bracket arm and pull them out at the front.
Pull out at least 60 cm of cable to complete the installation.
Warning:
Be careful when routing the cables through the bracket arm. A damaged cable may damage the
camera, the housing and/or other system equipment.
5. Position the swivel (11) on the end of the bracket arm (12) with the two cables
coming through the open slot. Ensure that the swivel is positioned with F (front) at
the front and R (rear) at the back.
