XF40-Q2901 Explosion-Protected Temperature Alarm Camera
About events
About events
The event pages allow you to configure your product to perform actions when different events occur. For example, the product
can start a recording or send an email notification when motion is detected. The set of conditions that defines how and when
the action is triggered is called an action rule.
How to set up action rules
An action rule defines the conditions that must be met for the product to perform an action, for example record video or send an
email notification. If multiple conditions are defined, all of them must be met to trigger the action.
For more information about available triggers and actions, see
and
The following example describes how to set up an action rule to record video to a network share if there is movement in the
camera’s field of view.
How to set up motion detection and add a network share:
1. Go to
Applications
to start and configure AXIS Video Motion Detection. See the online help.
2. Go to
System Options > Storage
and set up the network share. See
.
How to set up the action rule:
1. Go to
Events > Action Rules
and click
Add
.
2. Select
Enable rule
and enter a descriptive name for the rule.
3. Select
Applications
from the
Trigger
drop-down list and then select
VMD
.
4. Optionally, select a
Schedule
and
Additional conditions
. See below.
5. Under
Actions
, select
Record Video
from the
Type
drop-down list.
6. Select a
Stream profile
and configure the
Duration
settings as described below.
7. Select Network Share from the
Storage
drop-down list.
To use more than one trigger for the action rule, select
Additional conditions
and click
Add
to add additional triggers. When using
additional conditions, all conditions must be met to trigger the action.
To prevent an action from being triggered repeatedly, a
Wait at least
time can be set. Enter the time in hours, minutes and seconds,
during which the trigger should be ignored before the action rule can be activated again.
The recording
Duration
of some actions can be set to include time immediately before and after the event. Select
Pre-trigger time
and/or
Post-trigger time
and enter the number of seconds. When
While the rule is active
is enabled and the action is triggered
again during the post-trigger time, the recording time will be extended with another post-trigger time period.
For more information, see the online help
.
About triggers
Available action rule
triggers
and
conditions
include:
•
Applications
– Use installed applications to trigger the rule. See
.
•
Detectors
-
Live Stream Accessed
– Trigger the rule when any stream is accessed and during edge storage playback.
This can for example be used to send notifications.
34
