Axion STIM-PRO X700, Instruction Manual

Page: 47 / 147

01 Channel 2 channels – with adjustable intensity
02 Intensity Adjustable, 0 – 100 mA (in steps of 1 mA)
with 500 ohm load on each channel
03 Pulse amplitude Asymmetrical, Bi-phasic square pulse
04 Output voltage 0 – 50 V
05 Power source 1 pc. 9V battery
06 Size 10.2cm (L) x 6.2cm (B) x 2.8cm (H)
07 Weight
150 grams (batteries included)
08
Pulse
rate
Adjustable, from 1 – 150 Hz, 1 Hz/step
09 Pulse width Adjustable, from 50 – 300 microseconds,
10 μ/step
10 ON
time Adjustable, from 2 – 90 seconds, 1 Sec./step
11 OFF time Adjustable, from 0 – 90 seconds, 1 Sec./step
12 Ramp time Adjustable, from 1 – 8 seconds, 1 Sec./step
13 Mode 5 TENS modes: B (Burst) N (Normal),
M (Modulation), SD1 (40% modulation),
SD2 (70% modulation) – 2 EMS modes: S
(Synchronous), A (Alternate) – P (Pro-
gram Mode) – 24 TENS programs (set by
default)
14 TENS Burst mode B Burst rate: Adjustable, 0.5 – 5 Hz – Pulse
Width adjustable, 50 – 300 μs –
Fixed internal frequency = 100 Hz
15 TENS Normal mode
N
The pulse rate and pulse width are adjus-
table. It generates continuous stimulation
based on the setting value
16 TENS Modulation
mode
M
Modulation mode is a combination of pul-
se rate and pulse width modulation. The
pulse rate and width are automatically
varied in a cycle pattern. The pulse width
is decreased by 50% from its original
setting in 0.5 second, then the pulse rate
is decreased by 50% from its original
setting in 0.5 second. Total cycle time is
1second. In this mode, pulse rate (1 – 150
Hz) and pulse width (50 – 300 μs) are
fully adjustable.
TECHNICAL DESCRIPTION
46
AXION
EN