AXIOMTEK UST100-504-FL Series, User Manual

Page: 28 / 64

UST100-504-FL Series u
ser’s Manual
Dip Switch & Connector Settings
20
3.2 Connectors
Please refer to pin assignments below:
3.2.1 DC-in Power Connector
The system supports the 9~36V (Default 12/24V) DC-in connector for system power
input.
Pins Signals
1 DC+
2 GND
3 ACC (Ignition)
( Figure 1 ) ( Figure 2 )
【
Note
】
C onnect the DC-in power connector for the UST100-504-FL in-vehicle
system as follows:
1. For in-Vehicle applications, the ACC Pin needs to be connected to
accessory power on the vehicle. If the test environment cannot
provide accessory power, refer to Figure 1.
2. For AT mode application, please refer to SW1 Switch Mode in
Section 3.1, and the ACC of the power connector is an empty pin as
shown in the figure (Figure 2.
3.2.2 Ethernet Connector (LAN1~2)
The board has two RJ-45 connectors for LAN1-2 Ethernet (Intel i211-AT) connectivity.
LED Lamp Status
A
Activity link LED (yellow)
OFF: No link
Blinking: Link established; data activity
detected
B
Speed LED
OFF: 10Mbps data rate
Green: 100Mbps data rate
Orange: 1GMbps data rate