AXIOMTEK AX10445 Series, User Manual

Page: 23 / 58

AX10445 Module Series User
’
s Manual
Technical Reference
15
Base A3 : used to set up the parameters such as (LCR)
wordlength, number of stop bits, parity and
baud rate. To generate the desired baud rate,
first set DLAB to 1. Load the low and the high
bytes of a divisor into the receiver buffer and
the interrupt enable registers, respectively.
(refer to the following table)
Baud Rate
(bits/sec)
Divisor
Baud Rate
(bits/sec)
Divisor
50 2304 2400 48
75 1536 3600 32
110 1047 4800 24
150 768 7200 16
300 384 9600 12
600 192 19200 6
1200 96 38400 3
1800
64
56000
2
2000 58
Reset DLAB to 0 for normal UART operation.
Base A4 : used to send signals such as DTR (Data
(MCR) Terminal Ready) and RTS
(Request To Send).
Base A5 (LSR) : indicates the status of the line.
Base A6 (MSR) : indicates the status of the modem.