AXIOMATIC AX140900RST, User Manual

Page: 14 / 42

UMAX140900RST. Ethernet to CAN Converter. Version 1 Page: 14-41
3.2 Ethernet Configuration
All Ethernet configuration parameters can be changed through the Main Settings web page,
except the MAC Address, which is programmed at the factory. The user-changeable
configuration parameters are presented in Table 2.
The user should avoid using special IP addresses (broadcast, multicast, loopback, etc.) when
configuring the
Device IP Address since this can lead to a permanent loss of communication
with the embedded web server.
Table 2. Ethernet Configuration Parameters
Configuration
Parameter
Default Value Range Description
Device IP Address 192.168.0.34 Any IP address
1
The device IP address. The embedded
web server uses the same IP address.
Device Port 4000 Any port value
except the
Web
Server Port and
the Discovery
Protocol Port
The device server port. The device is
listening to this port for incoming
connections. The
Discovery Protocol Port
(35100) and the Web Server Port should
not be used.
Device Port Type UDP {UDP, TCP} Type of the IP protocol used by the device.
The device server and client use the same
IP protocol.
Web Server Port 80 Any port value
except the
Device Port and
the Discovery
Protocol Port
The communication port of the embedded
web server.
Device Subnet
Mask 255.255.255.0 Any IP address
1
The device subnet mask. Used also by the
embedded web server.
Device Default
Gateway 192.168.0.1 Any IP address
1
The device default gateway. Used also by
the embedded web server.
Auto Connect to
Remote No {No, Yes} The device client state. When the Auto
Connect to Remote is Yes , the device
client is activated, and the device will try to
establish a connection with the remote
server.
Remote IP
Address 192.168.0.35 Any IP address The remote server IP address. Used by
the device client when the
Auto Connect to
Remote is Yes .
Remote Port 4000 Any port value The remote server port. Used by the
device client when the
Auto Connect to
Remote is Yes .
1
Must be assigned by the network administrator.
3.3 CAN Configuration
The CAN configuration parameters can be changed through the Main Settings , CAN ID Range
Filters, and CAN ID Mask Filters web pages.
The main CAN configuration parameters are available through the
Main Settings web page,
see Table 3.