25 |
A x i o m T o o l G r o u p
Before resuming from a Breakpoint, a HOME operation needs to have been performed if the machine was just
restarted.
3-
When ready to resume working from the stored Breakpoint, press
Run + (1-9)
together.
a.
Controller will display the same
Save Break
locations seen before.
b.
Use the
X+/-
buttons to highlight the desired file and press
OK
to select.
c.
The current g-code position for that break will be displayed. (
The g-code lines can be scrolled
through at this point and the break resumed anywhere in the list
).
d.
If that g-code position is acceptable, press
OK
.
e.
The display will have moved on to the file parameters that appear before all file operations. Once
these are approved the file will begin at the saved location.
4-
A second way to resume working from a stored Breakpoint would be to press the
Break Work
button.
a.
Select the file (either from Udisk or Internal memory).
b.
Prompt will give the following instructions. (Use X+/- buttons to scroll)
i.
Press
OK
to resume from existing break
ii.
Press any other key to display the break line number only.
c.
Approve speeds to begin machining if applicable
Power Failures:
During an accidental power failure, a soft version of a
Breakpoint
is set where the current parameters and
coordinates are automatically saved by the system. This information will become available to resume at the next
immediate start of the machine.
The information is not saved permanently, thus if it is not resumed at the next start of the machine, the
information will be lost.
When power is returned to the machine, perform a
HOME
operation. Afterwards the
Want to Restore
prompt will
be displayed.
Press
OK
to restart the unfinished file operation.
If the operation is Canceled, ability to resume from the saved location will be permanently
lost.
Summary of Contents for AUTO ROUTE PRO V5
