Operation Instructions
SZU 21-00
Chapter
2:
Power supply
6
© AXING AG • Reserving change in design and type - We cannot be held liable for printing errors 24.07.12
2
Power supply
There are three ways to establish the power supply of the device:
2.1.1
External power supply
Connect the external power supply to the DC-power supply socket (1).
Make sure the slide switch (2) is in the position (“EXT”).
2.1.2
Satellite receiver
The SAT-Navi can be operated by delivering the power remotely from a satellite receiver or
multiswitch (which may be supposed to be connected to the LNB after searching the Satellite).
The receiver/multiswitch should be able to deliver 600mA of current to the LNB!
Make sure the power supply selector is in the position (“EXT”).
Connect the LNB/IF input of the satellite receiver to the DC power supply input (8) of the SAT-Navi
If the SAT-Navi does not power up or switches off when trying to search satellites, the current
delivered by the receiver may be insufficient. Please use another receiver or another way of supply.
2.1.3
Internal batteries
Make sure, you have inserted fitting batteries into the compartment in the right direction.
Put the Power Supply Selector in the lower position (“BATT”) to activate battery operation.
You can use non-rechargeable and rechargeable batteries in AA size.
Low Voltage
If the voltage of any power source is lower than 13.3V, the red low voltage LED lights up
Take care, that the input voltage is always higher than 13.3V.
If you are using rechargeable batteries, switch off (to “EXT”) the device when the red LED lights up to
prevent the cells from total discharge.
Fig. 4: DC-power supply socket
(1),slide switch (2)
