Operation instructions | SKT 40-00 | SKT 80-00 | 8PSK/QPSK | COFDM Quattro/Octo Module
16
2016-01-11 | © AXING AG Switzerland | Subject to change in design and type; errors and misprints reserved
3.2.
Initialization phase 1
During the first phase of the initialization, the tuner settings required for the sender search run are made and
the sender search run is carried out.
The four tuners work independently from each other and after the same principle.
Choose the tuner with the button
Tuner 1…4
.
The SAT IF frequency of the transponder is
entered in the input field "
Frequency
(MHz)".
The input fields "
LOF Low Band
(MHz)"
and "
LOF High Band
(MHz)" correspond to
the oscillator frequencies of the LNB in low
and high band.
The default settings of the oscillator
frequencies are 9,750 MHz for the low band
and 10,600 MHz for the high band.
In the optional field "
Polarisation
", you can
switch from horizontal to vertical.
In the optional field "
DiSEqC
", the DiSEqC command signals can be turned off or set to switch a DiSEqC-
enabled multi switch on the positions 1 to 4.
If required, the operating voltage for the LNB can be switched off via the optional field "
LNB power
supply
".
After all settings have been made, click the button
SEARCH RUN
.
A rotating circle is shown on the right side
during the scanning process.
The
BIT ERROR RATE
is shown in the middle area. The amount of bit errors for the last 1,000,000 transferred
bits is calculated.
After a successful search run, the radio and TV senders are shown in the bottom area "
FOUND PROGRAMS
".
The table still contains information about program type and encoding.
