Operation Instructions | EoC 1-01 | Ethernet over Coax
12
2015-01-01 | © AXING AG Schweiz | Konstrukions -, Typenänderung, Irrtümer und Druckfehler vorbehalten
5.
Troubleshooting
5.1.
LEDs
LEDs
The LEDs indicate an "activity" and are used for troubleshooting.
Power LED off
Make sure that the network cable is connected correctly.
Make sure that the mains switch of the EoC modem is switched on.
LAN LED is not flashing
No data traffic. Check the following:
Are the router and the modem switched on?
Is the Ethernet cable connected firmly to the LAN port of the router/modem?
Can the PC - connected to the router - establish a connection to the Internet?
Press the EoC Reset button on each EoC modem for 10 seconds to restore the factory settings of the EoC
modem.
If necessary generate a new network key (see chapter 4 on page 12).
EoC LED off - is not lit
The EoC devices cannot be found.
Make sure that the EoC devices are connected to the same antenna network and that they use the same
network key.
Position the EoC modem closer to the computer or the EoC modem.
After having activated the network security, make sure that all EoC modems use the same network key.
If the problem occurs, after the network key has been changed, re-establish the factory settings of each
device again. Then, you can generate the key again (see chapter 4 on page 12).
Check whether your antenna system provides a return channel.
EoC-LED is lit in red
The line attenuation between the EoC modem is too high. Position the EoC modem closer to the master
device.
