Axiim Q UHD First Run Setup
First Run: The “First Run” wizard is presented to the user in three different ways. All three cases listed below will
perform the same “First Run” setup procedure.
1.
When the device is first powered on out of the box for the first time.
2.
After a “Factory” firmware reset.
3.
When a user selects “First Run” option in the UI under Support.
We have provided a run through of the “First Run” wizard outlined below:
1.
Welcome to Axiim Q Setup! Select Continue to proceed through the first run wizard.
2.
Select wireless network - Note: If you have it wired to Ethernet this “Select A Wireless Network” section will be
skipped.
3.
“Enter Passphrase for Wireless Network”: Enter the passphrase for the wireless network you have selected.
4.
Select “Skip” to continue to the next step in the wizard.
5.
WIRELESS SPEAKER SETUP: The Axiim Q UHD will search for speakers automatically. Once the Q is finished
searching the number of speakers found will be displayed. Press “Continue” if the number of speakers are
correct on the screen. Note: if the number is not correct check to make sure all your speakers are powered and
press the “Search Again” button in the UI.
6.
Select a speaker in the list of unassigned speakers on the left of the screen.
7.
After an unknown speaker has been selected the LED on the speaker and a locator tone will play from the
selected speaker.
8.
Now find the corresponding location on the screen with the speaker playing the tone based on placement of
the speaker in your room.
9.
Repeat for the remaining unassigned speakers until you have assigned a location for each speaker in your
system and select “Continue”.
10.
SPEAKER SETUP HAS CHANGED. WHAT DO YOU WANT TO DO? Press “Save” to continue and save your speaker
configuration or “Discard” to go back to speaker setup.
Note: The Axiim Q UHD supports the following network security protocols: WPA2, WPA, WEP
***** You are now ready to enjoy your Axiim Q UHD! *****
