2: U
si
ng x
S
el
ec
to
r •
14
Fig. 2-3: GPIO port pinouts.
The icon at the top-right of the screen indicates the function associated with a press of the knob adjacent to the
screen (advance to next page). Press it to go to the Node ID page.
Node ID Page
This page is used to set up xSelector using the front-panel controls.
Fig. 2-4: Node ID page.
On the right side of the page are two icons.
• The top icon (two boxes) represents the page change function triggered by a tap of the encoder (advance to
next page).
• The bottom icon is a pencil indicating there’s an “edit” function for this page;
press and hold
the encoder
knob for 10 seconds to enter Edit mode and change settings.
This page is intended for fast automatic setup as discussed in the Quickstart preface to this manual. For general
use, the page shows the Node ID, the Livewire channel number of the source created by the xSelector, and the IP
address of the device.
Summary of Contents for xSelector
