DETAIL OF PHONEX REMOTER FOR MACROTEL X2
| DETAIL OF PHONEX REMOTER FOR MACROTEL X2
42
15
DETAIL OF PHONEX REMOTER FOR MACROTEL X2
15.1 DESCRIPTION OF MACROTEL X2 CONTROL SOFTWARE
The Macrotel X2 control software (Hybrid Remoter) is basically divided into 5 parts:
1.
Hybrid 1
section
2.
Hybrid 2
section
3.
Levels
section
4.
GPI / GPO status
section
5.
Setup & Disconnect
section
15.2 HYBRID 1 SECTION
The “Hybrid 1 Section” features a series of operating and monitoring controls relating
to the telephone hybrid 1 connected to a PSTN/POTS line.
The monitoring part concerns the Receive(Rx) and Send (TX) levels and shows
whether Macrotel X2 is in
Limiting
operating mode; it also shows the line status, ring
and echo canceller. When a parameter is active the relevant green LED lights up (in
this case Echo Canceller is active).
As regards device operation, the controls available are:
ON HOOK
– ATTEN – HOLD – DIAL
ON HOOK:
in this status Macrotel X2 can hook an incoming call or open the telephone line. Upon
receipt of a call the LED of the incoming call flashes on the front panel and the Hybrid Remoter
displays the RINGING Line Status for the hybrid with the incoming call.
The LED lights up in the GPO Status section. The open collector of the GPIO communication port
closes. See the appendix at the end of this manual for the pinout and connections.
To end a call, click OFF HOOK or press HOOK-1 again on the front panel; the latter remains switched on for the entire
time of the telephone call.
