350-Watt Digital VHF LB Transmitter
Chapter 3, Installation and Setup Procedure
DT325B, Rev. 0
3-10
Table 3-6: Menu 12 - Transmitter Device Data Access Screen
This screen of the transmitter allows access to various parameters of the transmitter
system. This is the entry point to Menu 30, the System Details Screens, by pausing the
ENT button. When the ENT button is pushed, Menu 30 is accessed. Go to Menu 30,
Table 3-11 for set up details. Before pushing the ENT button: if the
↓
key is activated
the display changes to Menu 13, Transmitter Configurations Access Screen. If the
↑
key
is activated the display returns to Menu 11, the Error List Access Screen.
Table 3-7: Menu 13 - Transmitter Configuration Access Screen
This screen of the transmitter allows access to various software settings of the
transmitter system. If ENT is pushed, go to Menu 40, Table 3-12, the access to
transmitter configuration and set up. Before pushing the ENT button: if the
↓
key is
activated the display returns to Menu 10, Main Screen. If the
↑
key is activated the
display returns to Menu 12, the Transmitter Device Data Access Screen.
Table 3-8: Menu 20 - Error List Display Screen
This screen of the transmitter allows access to the system faults screens. Fault logging is
stored in non-volatile memory. The transmitter's operating state can not be changed in
this screen. The 'CLR' switch is used to clear previously detected faults that are no
longer active. The
↑
key and
↓
key allow an operator to scroll through the list of errors
that have occurred. The ESC button is used to leave this screen and return to Menu 11,
Table 3-5, the Error List Access Screen.
NOTE:
Shown is example of a typical screen.
Menu 30 is entered by selecting ENT at Menu 12, Table 3-6
.
Table 3-9: Menu 30 - Transmitter Device Details Screen
This screen allows access to the transmitter parameters of installed devices. The system
is configured to know which devices are present. Current values for all installed devices
are shown. If a module is not installed, only a "MODULE NOT PRESENT" message will be
displayed. The first screen displayed is Menu 30-1, Table 3-10, the System Details
Screen.