Page | 9
Step 4:
Laying out the Right, Middle, and Left Panels onto the Assembled Frame
Parts Required (3’)
1-(g) Left Panel
2-(h) Middle Panels
1-(i) Right Panel
Drill
Parts Required (4’)
1-(g) Left Panel
3-(h) Middle Panels
1-(i) Right Panel
Drill
4a) Begin with the (g) Left Panel; the starting panel. Make sure the left side of the Left Panel
is the side/lip hanging down over the (d1) Left Side Frame. This will cover the left side
of the awning frame when the (b) Front Bar is closest to you.
Refer to figure C1 below
.
4b) Apply the (h) Middle Panels as shown in the figure below. The Middle Panels’ seams,
located on the left side of each Middle Panel, will be laid on top of the right side of the
panel that was set before it. Continue this process until 4c).
4c) Finish assembling the panels with the (i) Right Panel. Make sure the right side of the (i)
Right Panel is the side/lip hanging down over the (d2) Right Side Frame. This will cover
the right side of the awning frame when the (b) Front Bar is closest to you.
Figure C1:
Layout of Panels for Houstonian 4ft Example
