Page | 17
Step 10:
Mounting the Back Bars of the Assembled Awning to the Surface
Parts Required (3’ & 4’)
Mounting Hardware (Consult a Professional)
Drill
10a)
Using the mounting tabs
of the (j1) Left Back Bar and the (j2) Right Back Bar
as a reference, mark the location on the mounting surface using chalk/graphite noting
the location of the holes to be drilled.
10b)
Drill the pilot holes onto the specific markers.
Please refer to Figure I1
.
10c)
Prepare the pilot holes using professional recommended mounting hardware, M8 or
M6 Anchors may be useful here, for your surface.
10d)
Once the mounting surface is prepared, mount the frame of the awning. Specifically,
the tabs of the (j1) Left Back Bar and the (j2) Right Back Bar can be installed into the
prepared anchors. The awning should fit underneath the (n) Shroud (Hood Cover).
Please refer to Figure I1.
10e)
Secure the awning to the mounting hardware.
Please refer to Figure I1.
Figure I1:
Mounting the Awning onto the wall (please note that the diagram below does not
have its panels installed – this allows the reader visibility into the mounting process)
