Copyright 2022, AWE. No part of this document may be reused or duplicated without the express permission of AWE. All rights reserved. Rev 1.3
Slide one of the provided exhaust clamps onto
the end of the pipe (
A
). Then install your AWE
HR5 section (
E25
), as shown in
Figure 5
.
Note:
Snug the clamp but do not fully tighten it
at this point.
Place a provided exhaust clamp over the
expanded end of your AWE overaxle inlet tube
(
E26
), shown at (
A
) in
Figure 6
.
Bottom the slip fit on the HR5 section (
E25
).
When the tube is bottomed out slide the hanger
bars into the hangers as shown at (
B
) in
Figure 6.
Note:
Snug the clamp down but do not tighten
it fully at this time.
