Copyright 2022, AWE. No part of this document may be reused or duplicated without the express permission of AWE. All rights reserved. Rev 1.3
OE DUAL REAR EXIT EXHAUST REMOVAL
1.
To begin you will loosen the OE ball socket
clamp, shown at (
A
), enough to separate the
two components.
2.
Remove the 5 OE hangers from the exhaust
shown at (
B
).
3.
With the OE exhaust no longer attached to
the vehicle, remove the complete exhaust.
4.
Remove the OE tip bezels by removing the
3 bolts per side marked at (
C
). On each
bezel, all 3 bolts are located on the top side.
Note:
The factory clamp will be used with your
AWE exhaust.
Note:
The OE tip bezels will not be reused.
Note:
After the OE exhaust is completely
removed, re
-
install the OE heat shield,
and the spare tire.
Soak all bolts and rubber hangers in
penetrating oil before starting any work.
Start by removing the OE dual exit
exhaust by following the steps, shown in
Figure 2B
.
