Award TL-EMBSBC 795, User Manual

Page: 42 / 68

BIOS SETUP
38 TL-EMBSBC 795 User’s Manual
IDE Primary/Secondary Master/Slave UDMA
These fields allow your system to improve disk I/O throughput to
33Mb/sec with the Ultra DMA/33 feature. The options are
Auto and
Disabled .
Init Display First
This field allows the system to initialize first the VGA card on chip or
the display on the PCI Slot. By default, the
PCI Slot VGA is initialized
first.
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller installed on
the CPU card and you wish to use it. If you install an add-in FDC or the
system has no floppy drive, select Disabled in this field. This option
allows you to select the onboard FDD port.
Onboard Serial/Parallel Port
These fields allow you to select the onboard serial and parallel ports
and their addresses. The default values for these ports are:
Serial Port 1 3F8/IRQ4
Serial Port 2 2F8/IRQ3
Serial Port 3 3E8H/IRQ10
Serial Port 4 2E8H/IRQ11
Parallel Port 2 dISABLED
UART 2 Mode
This item allows you to determine which Infra Red (IR) function of
onboard I/O chip. The options are
Standard , IrDA , and ASKIR .
Parallel Port Mode
This field allows you to determine parallel port mode function.
SPP Standard Printer Port
EPP Enhanced Parallel Port
ECP Extended Capabilities Port
Onboard Legacy Audio
Enable or disable the on board legacy audio with this option. If
enabled, some audio options will appear.