12
OPERATION
PAPR POWERED AIR RESPIRATOR
There is a LCD display screen on BREATH-CLEAN Power unit to show the status of the unit.
FIGURE 3
Switch the device on by pressing the ON button once.
Press the ON button once again, the air flow is at level 1 (~170L/min).
Press the ON button once again, the air flow is at level 2 (~200L/min).
Press the ON button once again, the air flow is at level 3 (~230L/min).
Press the ON button once again, the air flow reverts to level 1 (~170L/min).
1. Respiratory system will turn off the turbo unit if the OFF button is pressed for more than 3 seconds.
2. Respiratory system will cut off the entire circuit and switch to sleep mode if the turbo unit has been turned off for
more than 30 minutes.
3. The Respiratory system must be operated in the temperature range of -5
℃
to +55
℃
and relative humidity less than
90%RH.
ADF AUTO DARKEN LENS
BEFORE USE
-Check for light tightness and check the inside & outside protection lens are clean and that no dirt is covering the
sensors on the front of the
auto-darkening-filter
(ADF)
cartridge.
-Make sure the protection films on both inside & outside protection lens are removed.
-Inspect all operating parts for signs of wear or damage. Any scratched, cracked, or pitted parts should be replaced
immediately.
Part 1 shows the data of current air flow.
Part 2 shows the level of the airflow.
Part 3 shows the filter condition.
Part 4 shows the battery.
Part 5 shows the temperature of the battery.
Will flash if there are problems with that particular function.
Summary of Contents for BREATH-CLEAN PAPR
Page 19: ...19 PARTS BREAKDOWN ...
Page 21: ...21 NOTES ...
