AW BREATH-CLEAN PAPR, Installation, Operation, And Parts Manual

Page: 9 / 22

9
INSTALLING THE BATTERY/CHARGING
1
Slide the battery towards the back of the
filtration unit.
2
Make sure that the battery is locked in
position.
3
The battery can be charged on the filtration unit or separately.
The battery is partially charged when delivered. It must be charged at a 100% (4 bars) before the first use.
It is recommended to charge the batteries at a 100% before each use.
The charger must not be used for anything else than it was designed for. Do not charge the battery in a potentially explosive
area. The charger must only be used indoors.
The charger regulates the charge automatically, once the battery is fully charged, it will maintain it at a 100% (floating
charge).
The charge time is 3 to 4 hours.
The battery will discharge itself after long storage periods. Always charge the battery if the device was stored for
more than 15 days. When the battery is new or has been stored for more than 3 months, charge it and discharge it at
least twice in a row to reach the nominal/rated charge capacity.
How To Charge The Battery :
Connect the battery to the charger. The connector is above the battery.
1. Connect the charger a 110 volt outlet
2. The state of charge is displayed via a red LED on the outlet charger.
3. Once the charge is finished, the floating charge becomes active: the red LED switches off and a green LED switches on.
4. Disconnect the charger from the mains (do not keep the charger plugg
ed to the mains if it’s not in use).