8
Application Note 006
Control Tool Quick Start Guide
CONFIGURATION TAB
In this tab, user can verify the information about the detected module. Make sure that the Serial number is corresponding to the one written on the label on
top of the module. If there is any problem about the information of the module, user is advised to reset the module using the reset button (red push button on
the evaluation board) and click the check com port button to update the information or relaunch the tool. The plots control panel is used when the demo is
launched.
AUTO DEMO TAB
This tab is used to launch the demo of the algorithms in order to evaluate their performance. To use this tab user must have a LoRa gateway at disposition.
Otherwise the demo cannot be launch.
When the button Start Demo is clicked, if the module is not yet joined the network, the join procedure will be initiated. The join procedures will take up to ~45s.
The status of the current process will be displayed inside the status text box. If the selected demo type is not supported by the module, a message box will
be displayed. The MCD algorithm can only be evaluated on the active EVB. Once demo is correctly started, user can change to plots tab to see the plot of link
quality and information.
Figure 12
Figure 13
092419
