Page 2
Mini UPS and Power Sensor (RMA-MUPS-SEN)
Install Your MUPS
Do not use this sensor in hazardous (classified) locations or life safety applications.
Step 1: Mount your MUPS.
1. Position your MUPS close enough to the power source that the power adapter cord will
reach. (Don’t connect power yet—you’ll do that in a later step.)
2. Mount your MUPS with screws through the flange holes, secure it with Velcro or simply
place it on a flat surface.
Step 2: Connect your MUPS switch port to Room Alert.
Do not connect the switch sensor inputs (dry contacts) on AVTECH products to any live
circuit.
Use only low-voltage 2-wire cable to connect switch sensor inputs.
Your MUPS comes with one end of the 25' speaker cable already
attached to its switch port, which is non-polarized. Follow these
steps to attach the other end to a switch port on your Room Alert:
1. Separate and strip the leads on the free end of the speaker
cable, exposing about 1/4" of wire.
2. Run the speaker cable back to your Room Alert. Try to avoid running it near large
electromagnetic devices or fluorescent lights, which produce EMI and can interfere with
sensor readings.
3. Connect the free ends (the 1/4" leads) of the speaker cable to an
open switch port on your Room Alert. Be sure the bare wire, not the
insulation, connects to the port. Again, the leads are non-polarized, so
you may connect either lead to either side of the open port.
Step 3: Connect your MUPS power output cord to Room Alert.
Your MUPS comes with a built-in power output cord with a barrel
connector.
Connect this cord to the power port on your Room Alert (or other 5V
device you wish to power using the MUPS).