riasztobolt.hu
6
STEP 5: Set the speed dome camera at the DVR side.
Go to “ADVANCE CONFIG”
l
“REMOTE” to set the speed dome camera.
a) Select the device to “PTZ”.
b) Set the ID to the value the same as the one set in the speed dome camera. The default ID of the
camera is 000.
c) Select the protocol to “NORMAL”.
d) Set the baud rate to the value the same as the one set in the speed dome camera. The default baud
rate of the camera is 2400.
ADVANCE CONFIG
CANERA
CH1
CH2 CH3 CH4
DETECTION
DEVICE
PTZ
ALERT
ID
000
NETWORK PROTOCOL
NORMAL
SNTP
RATE
2400
DISPLAY
RECORD
REMOTE
EXIT
2.3 DVR Power On
This device should be operated only with the type of power source indicated on the manufacturer’s label. Connect
the indicated AC power cord to the power adapter, and plug into an electrical outlet. The power LED will be on.
Note:
Before the DVR is powered on, make sure the cameras are connected and power-supplied for the
detection of the camera video system to be correct.
Note:
To ensure that your DVR works constantly and properly, it's recommended to use an UPS,
Uninterruptible Power Supply (Optional), for continuously operation.
2.4 Date and Time Setting
Before operating your DVR, please set the date and time on your DVR
FIRST
.
Note:
Please DO NOT change the date or time of your DVR after the recording function is activated.
Otherwise, the recorded data will be disordered and you will not be able to find the recorded file
to backup by time search. If users change the date or time accidentally when the recording
function is activated, it’s recommended to clear all HDD data, and start recording again.
Note:
For the first time to use the DVR, please power it on for at least 48 hours continuously after the
date & time is set correctly. It helps to prevent DVR time from resetting after the disconnecting of
DVR power. If the DVR time resets after the disconnecting of DVR power, for example, caused by
a power outage, the battery might run out and please replace the battery as described in
“APPENDIX 6 DVR BATTERY REPLACEMENT” at page 44.
Right-click to enter the DVR password with the password keypad. The default administrator password is 0000.
The status will be changed from
(key lock) to
(administrator). Then, right-click to show the main menu,
and select “QUICK START” “TIME SETUP” to set the date & time.
Summary of Contents for AVC-793
Page 37: ...riasztobolt hu 33...
