Avtech AV-1030-B, Instructions Manual

Page: 30 / 42

In the above example, the pulse width of the output was set by a programming
command. To set the output pulse width to track the trigger pulse width in external
mode, use:
*rst (resets the instrument)
trigger:source external (selects internal triggering)
pulse:width in (PW
OUT
= PW
IN
)
output:type TTL (sets the logic outputs to TTL mode)
volt:ampl 5 (sets the amplitude to 5 V)
output on (turns on the output)
These commands will satisfy 90% of your programming needs.
ALL PROGRAMMING COMMANDS
For more advanced programmers, a complete list of the available commands is given
below. These commands are described in detail in the “Programming Manual for -B
Instruments”. (Note: this manual also includes some commands that are not
implemented in this instrument. They can be ignored.)
Keyword Parameter Notes
DIAGnostic:
:AMPLitude
:CALibration <numeric value> [no query form]
LOCAL
OUTPut:
:[STATe] <boolean value>
:PROTection
:TRIPped? [query only]
:TYPE TTL | ECL
REMOTE
[SOURce]:
:FREQuency
[:CW | FIXed] <numeric value>
[SOURce]:
:PULSe
:PERiod <numeric value>
:WIDTh <numeric value>
:DCYCle <numeric value>
:HOLD WIDTh | DCYCle
:DELay <numeric value>
:DOUBle
[:STATE] <boolean value>
:DELay <numeric value>
:GATE
:TYPE ASYNC | SYNC
:LEVel HIgh | LOw
[SOURce]:
:VOLTage
[:LEVel]
30