29
28
MAX
AUF / UP
AB / DOWN
GELB / YELLOW
MIN
AUF / UP
AB / DOWN
WEISS / WHITE
LOSS OF WARRANTY
The projection screen is properly adjusted at factory
and the adjusting screws are sealed. Changing of the
minimum or maximum final position is not necessary.
Important: Any damage caused by the adjustment of
final positions is not covered by warranty.
Note: Should it be necessary to adjust the final positions
by applicational reasons, only skilled personnel is allowed
to do so.
Do the adjustment in small steps (one-quarter turn)
and check the result by unwind and rewind the fabric
completely.
Adjustment of the final position MAX:
Remove the plastic cap on the bottom side of the
projection screen. (see sketch MAX)
To set the final position MAX higher, turn the yellow
adjusting screw slightly to the right (clockwise).
(see sketch MAX)
To set the final position MAX lower, turn the yellow
adjusting screw slightly to the left (anti-clockwise).
CAUTION: Do not allow the screen to go beyond the
STOP-limit !
Adjustment of the final position MIN:
Remove the plastic cap on the bottom side of the
projection screen. (see sketch MIN)
To set the final position MIN lower, turn the white
adjusting screw slightly to the right (clockwise). (see
sketch MIN)
To set the final position MIN higher, turn the white
adjusting screw slightly to the left (anti-clockwise).
CAUTION: Do not allow the batten to be pulled into the
screen casing !
S T O P P O S I T I O N A D J U S T M E N T
Motor left / Fabric in front
and Motor right / Fabric back
