154.038UK User Manual
Installation
The PAR-180 is supplied with a dual hanging bracket, which can also be used as a free-standing support.
When installing the fixture, ensure all fixings are secure, controls and connections are accessible and do not
obstruct the rear cooling fan vent.
Operation
Static colour
To select one of the preset static colours, press MENU until the display shows
xx
or
xx (where “
**
” is a
number).
Press the UP/DOWN buttons until
to
is displayed
and press ENTER to select one of the static
colours listed in the onboard menu section.
Auto programs
To select auto colour change or scroll, press MENU until the display shows
**
or
** (where
“
**
” is a
number). Press the UP/DOWN buttons until
or
is displayed
and press ENTER to select. Press the
MENU button again until the display shows
-
enters the speed adjustment for the program, which
can be set using the UP/DOWN buttons.
Strobe setting
In static colour mode, pressing MENU until
** is displayed
(where “
**
” is a number
) enters the strobe
mode.
is no strobe, whereas
-
strobe speeds can be set using the UP/DOWN buttons. The
strobe effect will flash the selected static colour.
Sound-to-light
To select the sound-to-light function, press MENU until the display shows
xx
or
xx
(where “xx” is a
number), press the UP/DOWN buttons until
or
is displayed
and press ENTER to select.
is a sound activated colour change and
is a sound activated colour changing strobe effect.
Master/slave mode
To use in Master/Slave mode, connect PAR-180 units with XLR cables from DMX out to DMX in as a daisy
chain. On the Master unit (first in the daisy chain), using the 4 control buttons on the back panel, select your
chosen program. All subsequent units in the daisy chain should be set to DMX address
to set them up as
Slave units. These will then mimic the output of the Master unit.
DMX mode
To control the fixture via a DMX controller, simply connect the DMX signal source (controller) to the
‘
DMX in
’
of the unit using a balanced XLR lead. Additional fixtures can be controlled by the same DMX signal by
connecting an XLR cable from DMX out of the first unit to DMX in of the second unit, DMX out from the
second unit to DMX in of the third unit and so on... For long daisy chains, it is advised to use a DMX
terminator plug on DMX out of the last fixture.
Press the UP/DOWN buttons to set the DMX start address
-
