8
Place the bevel on the marks A and B, and
draw the contour lines. With a cutting tool
remove the space that must be occupied by
the gate.
The installer should locate his working
position in the square of the technical ceiling
plate, adjacent to the Cinema Mirror
installation.
Move the Cinema Mirror-projector set as
much as is necessary to install the modified
technical plate.
Place the Cinema Mirror-projector set in the
space chosen.
Lightly press the bevel pins outwards and
adjust them to the gate.
Check the light-image on the screen.
Provide the finishing touches to the ceiling
finish according to the characteristic
requirements of the space.
FINAL FINISH OF THE CEILING
Once we are definitively satisfied with the
image obtained, we will proceed to close the
ceiling with the same material used by the
maker of the technical ceiling. If you use
other materials, try to use materials with a
very low weight. Consult the possibilities of
painting or masking of the material used for
a correct simulation with the original ceiling.
ATTENTION PLEASE!
The motor system
(active door) is not prepared to carry heavy
loads, as for example, parts in wood, cork,
glass, etc., that one might want to install on
the door as decoration items.
If you desire this, try to modify the finish, by
painting or imitating the painting by means
of a very thin foil, to be able to integrate the
finish of the door of the Cinema Mirror to
the roof decoration in which it is installed.
Take the measurements in which the gate
was located with the frame, measurements
A and B (Fig 8). Mark the measurements A
and B on the technical ceiling plate
(60x60cm), (or replacement material).
figure 8
MAINTENANCE
The mechanics and mobile parts of the
equipment don't specify of a severe
maintenance, but if it is convenient the
application of a lubricant in the mobile parts,
with a minimum periodicity of 90 days.
Revise the electric installation and its
connections, likewise revise the anchorage
from the unit to the roof.
The optic lenses will clean with non abrasive
cloths, using neuter soaps or simply with
common water.
A
B
INSTRUCTIONS AND TIPS FOR THE INSTALLATION
OF THE HC 37.53 MODEL CINEMA MIRROR
GENERAL RECOMMENDATIONS FOR ASSEMBLY AND INSTALLATION
