AVProEdge AC-MX88-AUHD-NSFS, User Manual

Page: 15 / 25

AVPROEDGE - 2222 E 52ND ST N SIOUX FALLS. SD 57104 - 1.877.886.5112 - + 1.605.274.6055 - SUPPORT@AVPROEDGE.COM
1. Connect your computer to one of the control ports (Micro USB/3pin Terminal)
2. Open up MyUart and verify the correct settings
a. Baudrate: 57600, no parity, 8 data bits and 1 stop bit) with no handshaking.
3. On MyUart c lick Search Port>> (you will see a red indicator once connected)
a. You can verify the COM port by using Windows Device Manger. Both USB
and 3pin connections should show up as a COM # .
4. Send "GET DHCP" with a carriage return (no " " and hit Enter/Return on keyboard ) .
a. Default is OFF so the return message should be " DHCP 0 " (0=Off, 1=On)
5. Send "SET DHCP 1", the return message should read " DHCP 1 "
a. This will also return the current IP Settings. If there is no connection it will
reply with the Default Settings .
6. You can now connect to the WebUI by typing in the HIP address into a web
browser. There you can alter the IP address of the Matrix to one of your choosing.
7. You can also set the address of the matrix by sending the following command
a. "SET HIP xxx.xxx.xxx.xxx" (SET HIP 192.168.1.143)
8. Once configured it is recommended to turn DHCP back off so the settings are set
to Static and will not change (this can also be done from the WebUI).
a. "SET DHCP 0"
9. You can verify the settings by getting the status of the matrix
a. "GET STA"
RS-232 and TCP/IP Commands:
The Matrix can be controlled with either RS-232 or TCP/IP commands. Certain switching or format configurations can
only be done using these commands. We recommend using either the MyUART (RS-232 - free) or Hercules (TCP/IP - free)
apps as they are very easy to use for sending commands to the machine.
For TCP/IP control commands use Telnet Port 23.
For RS-232, use a null modem serial cable adapter and set the serial communications to:
57600,n,8,1 (baud: 57600, no parity, 8 data bits and 1 stop bit) with no handshaking.
Please add a return (Enter key) after each command when using direct commands. The
unified command list (ASCII) is listed on the next page .
Command Example: DHCP and setting the IP Address
AC-MX88-AUHD-NSFS
Page 15