The CM7x cameras have the ability to import or export a configuration.
Execute the following steps to import or export your configuration parameters:
1.
Select the appropriate button to import or export your configuration parameters.
2.
Follow the steps in the wizard that appears.
The exported settings do NOT include any presets that are stored in the camera!
P/T/Z
Figure 46: WebGUI > SYSTEM > P/T/Z
In this window, you can define various P/T/Z settings for your camera. These are:
PTZ Speed
It is possible to increase the maximum pan and tilt speed, this can be useful in a conference system
where quick action is necessary. The camera will produce slightly more noise when this setting is set to
‘high’.
Speed by zoom
This mode affects PTZ speed when the camera is zoomed in to its max. If you move the stick of your
controller when this mode is disabled, it will move too fast to control it. Enabling reduces this speed in
relation to the current zoom factor.
Image Freezing *
You can freeze the image when the camera moves from one preset to another preset when you use
your (remote) controller.
Low Power Mode
:
The camera will go in stand by mode to reduce its power when this mode is enabled. In order to reduce
the power the camera uses, the camera will shut down the IP Port. To activate the camera again, use a
serial connection or the IR Remote to set off the Low Power Mode.
Enable/ Disable Infrared
Receiver
:
It is possible to enable/disable the Infrared Receiver. Note that, when you disable the Infrared Receiver
and the Low Power Mode is enabled, it will
NOT
be possible to activate the camera again using the IR
Remote Control!
Zoom Speed
You can set the speed to which the camera will zoom in to the image. The higher the number, the faster
the camera will zoom in. This works only when the remote controller is used to control the camera.
Preset Pan, Tilt and Zoom Speed
This mode affects the speed to which the camera is switching from one preset to another when you use
your (remote) controller. The higher the number, the faster it will switch.
* If you are using audio during streaming, put it first
OFF
before freezing the image! Freezing the image
could produce a paused audio output on the IP Stream. This leads to (audio) stuttering.
The video stutters when it is re-engaged, but this is rather easily solvable by putting the iFrame value at 4 or
5 times per second, that is quick enough to counteract the video stutter.
MJPEG Snapshot
The Avonic CM7x-IP cameras are equipped with a MJPEG snapshot feature to, for example, implement into third
party software.
To access the MJPEG snapshot feature, use the following format:
Every time the page is refreshed, the picture will be updated.
40
Summary of Contents for CM70-IP
Page 68: ...APPENDIX B DIMENSIONS 68...