AVOCOR AVF-6550, Installation And Operation Manual

Page: 44 / 76

Revision Date: 1/17/2020
44
HDMI HDCP
Select the HDCP Mode
Options: Enable All / Disable HDMI1 / Disable HDMI2 / Disable HDMI1 & 2
Default: Enable All
Firmware Update (USB)
Plug in the USB flash drive and select Yes to proceed with firmware update.
To start updating firmware, select Yes to continue.
Options: No, Yes
Restore Factory Reset
Restore all settings to their default value.
Options: No, Yes
Smart Light Control – By Time
By Time settings allow the user to set the brightness level of the display to a free range in % (between 0-100%)
during specific times of the day.
Wake Up from Sleep
By default, the display will enter power saving (Sleep Mode) if no signal is received for 5 minutes. Normally, the
RS-232, DisplayPort, and HDMI inputs are inactive in Sleep Mode, to save power.
To change the behavior of Sleep Mode, change the “ Wake up from Sleep ” setting in the “ Adv. Settings ” menu.

VGA Only (default) – The RS-232, DisplayPort, and HDMI inputs are inactive when the display is in sleep
mode. The display will wake up when it receives a signal at the VGA input.
Note: This option is only available when OPS Power State sets to “Follows Display”.

Digital, RS232, Ethernet, VGA – The RS-232, DisplayPort and HDMI inputs stay active when the display is in
sleep mode. The display will wake up when it receives a signal at either of the DisplayPort, HDMI, VGA or
RS-232 inputs, or via LAN connection.