Avnet MSC C10-MB-EV, User Manual

Page: 47 / 48

MSC C10-MB-EV User Manual
47 / 48
4.25 WLAN LEDs
There are three yellow LEDs placed near PCIe Mini Card slot. They indicate the card type.

Wireless Wide Area Network (WWAN).

Wireless Local Area Network (WLAN).

Wireless Personal Area Network (WPAN).
4.26 DIP Switches
There is an array of DIP switches at the card edge to configure various functions.

References: S2801, S2802, S2803, S2804, S2805.

Type: 4pol

Location: Card edge
Reference No. Function Description
S2804 4 LCD EPROM ENA (default on) Off enables carrier EDID EEPROM
S2804 3 BCKL ENA POL Backlight polarity, off = low active
S2804 2 LCD ENA POL LVDS enable polarity, off = low active
S2804 1 LID# On = 680R to GND
S2805 4 GPIN 3 On = GND
S2805 3 GPIN 2 On = GND
S2805 2 GPIN 1 On = GND
S2805 1 GPIN 0 On = GND
S2802 4 PEG_SEL# No function
S2802 3 eDP#/LVDS Select eDP / LVDS selection (on = eDP)
S2802 2 BIOS DIS 0 (default off) BIOS selection table at chapter 4.17
S2802 1 BIOS DIS 1 (default off) BIOS selection table at chapter 4.17
S2801 4 PSON S5# Selects source for PSON signal.
S2801 3 PSON S4# Selects source for PSON signal.
S2801 2 PSON S3# (default on) Selects source for PSON signal.
S2801 1 AT MODE ATX always on (PSON is set to GND)
S2803 4 SIO ENA / OFF = DIS On enables SIO W83627
S2803 3 SIO CFG ADR 4E=ON/2E=OFF SIO address selection (default off, 2E)
S2803 2 SIO KBD ENA SIO keyboard controller enable (on)
S2803 1 SIO 48MHz=ON/24MHz=OFF SIO PEN48 (default on, 48MHz)
Table 28 DIP Switch Overview
4.27 Ground Pins
There are several ground pins spread over the base board for connection of measurement
equipment.