9
Personal Setup
Menu (see also section 3.1 ), the volume of the analog outputs of your CD 30.3
can be adjusted using the
VOLUME
keys on the RC 3 or RC 8 remote control.
NOTE:
When using the RC 8 remote control (available as an accessory), sampling rate and filter
can also be switched (<
FILTER
> keys). Furthermore, the number keys of the RC 8 can be
used to directly select a specific title of a CD (one or two digits).
Please note the following if the remote control does not work properly: Always hold the remote
control with the front end facing the device you want to operate. If the remote control is placed
too far away from the device to be controlled, or if the batteries are dead or objects are placed
between the remote control and the device to be controlled, the remote control may not
function properly.
1.8.1
Battery replacement
Bottom of the RC 3 remote control
If the range of the remote control decreases significantly, new batteries must be installed.
Remove the six screws on the bottom of the remote control marked with arrows (
ATTENTION
:
do not open the two middle screws without arrow marking!) Now turn the remote control over
and take out the bottom with the printed circuit board. Now remove the used batteries and
replace them with two new ones of the same type (Lithium button cell 3V, type CR2032). Make
sure that the polarity of the batteries is correct when inserting them (marking "+" upwards),
otherwise the electronics may be damaged.
Summary of Contents for CD 30.3
Page 1: ...Operating Instructions CD 30 3 ...
Page 2: ......