Warnings
Not Intended For Dialing Emergency Medi-
cal Services
The CA300 is not intended to make emergency calls� In the
event of an emergency, the user should use a telephone or
device other than the CA300 to call local emergency ser-
vices�
Use medically approved devices
Ensure that any device connected to the CA300 power out-
lets conforms to IEC 60601-1 standards in order to maintain
compliance� Connecting electrical equipment to the CA300
effectively creates a new system, which can result in a
reduced level of safety�
Loss of Connectivity
During the use of the CA300, a healthcare professional
may lose connectivity with the system� Loss of connectivity
can result from power outages, network outages, failure
in the CA300 software/hardware, or other causes� Loss of
connectivity can prevent a health care professional from
completing a patient session in a timely manner� In cases
where time is critical, the user should not use the CA300
and seek an in-person examination from a licensed health
care professional�
Delay or Choppiness of Audio or Video
Transmission
The CA300 may operate at a delay of up to 150 millisec-
onds, depending on network condition� This means that
the provider may experience the audio and video transmis-
sions later then they are really occurring� In cases where the
remote health care provider needs to make time sensitive
assessments or give instructions this delay may result in
misalignment of audio and visual transmissions to the
real-time procedure and/or inappropriate treatment or
diagnosis�
Proper Training Is Required
Healthcare professionals using the CA300 should be suf-
ficiently trained and familiar with the Installation and User
Guide and the instructions for use� Please refer to this guide
under “Troubleshooting”, “Safety Precautions” and “Opera-
tor Safety�”
See
http://avizia.com
�
Audio and Video Distortions
The CA300 can experience audio and video distortions due
to network latency, software/hardware malfunction, insuf-
ficient bandwidth, or for other reasons� If audio or video is
not of sufficient quality for the intended use of the CA300,
please refer to:
• this guide under “Technical Specifications” and “Trou-
bleshooting,” or visit:
http://avizia.com/support
• Cisco SX20 codec documentation at:
http://cisco.com/go/sx-docs
Network and Signal Input/Output
The network and signal input/output ports must only be
connected to Low Voltage SELV connections�
CA300 | Installation & User Guide
Warnings
© 2017 Avizia Inc. All rights reserved. | avizia.com | AVZ-CA300-DOC-UIG-04
6
| Before getting started