Avital Phoenix 2, Installation Manual

Page: 15 / 21

Hood/Trunk Pin Switch
1. Locate the vehicle hood or trunk pin switch that shows ground when the
hood or trunk is open only.
2. Connect the TAN
wire to the vehicle hood or trunk switch wire.
3. If the vehicle does not have a hood or trunk switch, install a pin switch
and connect it to the TAN wire.
Siren
1. Choose a location in the engine compartment away from high heat engine
components, moving parts and direct exposure to water.
2. Make sure the siren and siren wires cannot be seen or reached from
below the vehicle.
3. Mount the siren with the two self tapping screws to a solid metal surface.
4. Connect the siren
BLACK wire to the alarm module VIOLET wire.
5. Connect the siren RED wire to the alarm module RED wire.
Power and Ground Connections
I
CAUTION
: Do not plug in the system fuses until the final step
below.
1. Connect the RED
wire to one of the supplied fuse assemblies.
2. Connect the
RED/WHITE wire to the other fuse assembly (if the vehicle
parking lights are (+) positive).
3. Connect the fuse assembly(s) to one of the supplied 10mm ring terminals.
4. Connect the
BLACK wire to the other 10mm ring terminal.
5. Remove the (+) and (-) battery bolts. Do not disconnect the battery
clamps.
6. Connect the empty fuse assembly(s) to the positive battery post.
7. Connect the
BLACK wire to the battery negative post.
8. Inspect all alarm wiring. Make sure all wires are connected.
9. Install the 5 amp fuse in the
RED wire fuse assembly.
10. Install the 20 amp fuse in the RED/WHITE
fuse assembly (if the vehicle
parking lights are positive).
13
Phoenix2 Rev. A - Installation Manual 0399