Avital AviStart 4500, Installation Manual

Page: 14 / 24

12
AviStart 4500 Installation Manual -0898 Rev. A
NOTE: Use the following test procedure upon completion of every remote
start regardless of the make and model of the vehicle
Test Procedure
I
CAUTION: Be sure there is at least 5 feet of unobstructed
clearance at the front and rear of the vehicle. Make sure to alert
anyone near the vehicle you are testing that the vehicle may move
forward slightly.
1. Apply the parking brake.
2. Turn the ignition key to the "ON" position and place the vehicle in
"DRIVE."
3. Turn the ignition as close to the "OFF" position as possible. (Most
vehicles will not allow the key to turn off completely.)
4. Place your foot over the brake pedal without touching it. Be prepared to
step on the brake if the starter engages.
5. Activate the remote engine starter.
6. If the vehicle starter engages, immediately press the brake pedal to
disengage (shut down) the remote start. You have a "combined" type
neutral safety switch and you will have to add an additional relay as
shown in the diagram.
7. If the vehicle starter does not engage, no additional relays are required.
All vehicles have a "key in the ignition" reminder circuit (key minder) that
will sound a chime or buzzer while the key is in the ignition and the driver’s
door is open. The following diagrams will illustrate how to interface the
key-minder wires and a relay to prevent the vehicle from remote starting
while the key is in the ignition.
The wire color codes are subject to change. Check all wires with a
volt/ohmmeter. If you have any questions, please contact the Avital
Technical Support Department.