1
16
6
© 2005 Directed Electronics—all rights reserved
((--)) LLiig
gh
htt FFllaassh
h O
Ou
uttp
pu
utt
hheeaavvyy ggaauuggee rreellaayy iinntteerrffaaccee
The heavy gauge wires are used to energize high current circuits in the vehicle. It is crucial that these connec-
tions are made correctly so that they are capable of handling the current demands. For this reason, scotch locks,
T-taps and other such connectors should not be used.
Remove the two 30 amp fuses prior to connecting these wires and do not replace them until the satellite has
been plugged into the control module. These wires are the source of current for all the circuits the relay satel-
lite will energize. They must be connected to a high current source. Since the factory supplies (+) 12V to the key
switch that is used to operate the motor, it is recommended that these wires be connected there.
N
NO
OTTEE:: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED
wire of the satellite to each feed at the switch.
Connect this wire to the ignition wire in the vehicle. (See
Finding the Wires You Need section of this guide.)
Connect this wire to the accessory wire in the vehicle that powers the climate control system. (See
Finding the
Wires You Need section of this guide.)
Connect this wire to the starter wire in the vehicle. (See
Finding the Wires You Need section of this guide.)
P
PU
UR
RP
PLLEE ((+
+)) ssttaarrtteerr o
ou
uttp
pu
utt
O
OR
RA
AN
NG
GEE ((+
+)) aacccceesssso
orryy o
ou
uttp
pu
utt
P
PIIN
NK
K ((+
+)) iig
gn
niittiio
on
n o
ou
uttp
pu
utt
R
REED
D ((2
2)) ((+
+))1
12
2V
V iin
np
pu
utt ffo
orr rreellaayyss
