© 2009 Directed Electronics
17
H1/9 YELLOW (+) ignition input:
Connect this wire to the (+)12V igni-
tion wire. This wire must show (+)12V with the key in Run position and
during cranking. Take care to insure that this wire cannot be shorted to
the vehicle chassis at any point.
H1/10 BROWN (+) siren output:
Connect this to the RED wire of the
siren. Connect the BLACK wire of the siren to (-) chassis ground, prefer-
ably at the same point as the control module’s BLACK ground wire.
H1/11 RED (+)12V constant power input:
Before connecting this wire,
remove the supplied fuse. Connect to the battery positive terminal or the
constant 12V supply to the ignition switch.
Always use a fuse within 12 inches of the point you obtain (+)12V. Do
not use the 15A fuse in the harness for this purpose. This fuse protects
the module itself.
H1/12 RED/WHITE (-) 200mA auxiliary channel/delayed accessory
output:
If programmed for an auxiliary output, this wire will provide a
(-) pulse when the lock button on the factory transmitter is pressed twice
within three seconds. This output can be used to control optional acces-
sories. If programmed for delayed accessory output, this wire will pro-
N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 17
