10
© 2001 Directed Electronics, Inc. Vista, CA
This wire supplies a (-) 200 mA output that can be used to honk the vehicle’s horn. It outputs a single pulse
when locking the doors with the remote, and two pulses when unlocking the doors with the remote. This wire
will also output pulses for 30 seconds when the panic mode is activated. If the vehicle has a (+) horn circuit, a
standard automotive SPDT relay or a relay assembly package (
p/n 8617
) must be used.
IMPORTANT!
Never use this wire to drive anything but a relay or a low-current input! This
transistorized output can only supply (-) 200 mA. Connecting directly to a high-current device will
cause the module to fail.
NOTE:
If this output is used to drive a (+) horn circuit, an optional standard automotive SPDT relay
or a relay assembly package (
p/n 8617
) must be used. See the following diagram.
This wire determines what the output polarity of H1/4 will be. If the door pin circuit is negative, connect to
chassis ground. If the door circuit is positive, connect to a fused 12V source.
H2/3 BLACK/WHITE input to on-board interior light illumination relay
H2/2 BROWN/BLACK (-) 200 mA horn honk output
