7
EN
Section 2
Getting Started
Loading the Battery
Before using the camcorder, you must load the supplied Lithium-ion
rechargeable battery.
Insert the battery according to the correct polarity marks ( + or -).
1.
Close the battery cover firmly.
2.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS .
Charge your battery
You must use the supplied AC charger or the USB cable.
The camcorder must be turned OFF; blinking light confirms charging, and the
light becomes constant when the charging has been completed.
In AC charging Mode, the light will turn itself off automatically after 3~5
minutes . The full charge time is about 3.5 to 4.5 hours. (Actual charging time
may vary. It depends on the battery conditions.)
Inserting and Removing an SD Card (Optional)
The camcorder comes with an internal memory which allows you to
store photos and videos. You can expand the memory capacity by
using an optional SD memory card.
Insert the memory card into the slot. Please refer to the figure on
1.
the right side.
To remove an installed SD card, press the card inwards to release
2.
it.
When the card pops out, gently remove it from its slot.
3.
Recommended memory capacity: 1GB or above.
4.
Note
When a memory card is fitted, videos/photos are saved
•
on the card rather than on the built-in memory.
Protecting Data on an SD Card: SD Card is read-only when it is locked. No photos or videos
•
can be recorded when the SD card is locked. Make sure the lock is on the writeable position
before recording any media.
Writeable
position
Write-Protected
Position
Summary of Contents for V22
Page 1: ......