Avigilon ENC-4PORT, Operating And Installation Instructions, Page: 13 / 24

13
Table:
Connection States of Connection Status LED
Connection State Connection Status LED Description
No Link Off The encoder is not
physically connected to
another network device
Obtaining IP
Address
One short flash every second The encoder is attempting
to obtain an IP address
Connecting to NVR Two short flashes every second The encoder has obtained
an IP address and is
attempting to connect to the
NVR
Upgrading
Firmware
Two short flashes and one long flash
every second
The encoder is updating it’s
firmware
Connected On The encoder is connected
to the NVR
IP Address Selection
The encoder automatically obtains an IP address. Once connected to a network, the encoder
will attempt to locate and obtain an IP address from a DHCP server. If this fails, the encoder
will use Zeroconf (APIPA) to choose an IP address.
When the encoder’s IP address is set using Zeroconf, its IP address is in the 169.254.*
subnet.
The encoder can be set to a static IP address from the Avigilon Control Center software.
Consult the software user guide for details.