Avigilon 1.0W-H3-BO1-IR, Installation Manual

Page: 14 / 139

6
English
• If you are surface mounting the camera, remove the
mounting gasket and tuck the connected cables to
one side through the cable entry notch in the
mounting bracket. When installed outdoors, the
cable entry notch must face downwards.
2. Ensure the mounting gasket is used when flush mounting
the camera.
The gasket is required to maintain the mounting bracket’s
water resistance when installed outdoors.
3. Drive the provided screws into the mounting holes and
tighten the camera bracket to the mounting surface.
Assigning an IP Address
The camera automatically obtains an IP address by default. Once
connected to a network, it attempts to locate and obtain an IP address
from a DHCP server. If this fails, Zero Configuration Networking
(Zeroconf) is used to choose an IP address. When the IP address is
set using Zeroconf, the IP address is in the 169.254.0.0/16 subnet.
The IP address settings can be changed using one of the following
methods:
• (Recommended) Avigilon Camera Installation Tool
software application.
• Camera's web browser interface:
http://
<camera IP address>
/
• ARP/Ping method. For more information, see Setting the
IP Address through the ARP/Ping Method .
• Network Video Management software application (for
example, Avigilon Control Center).
NOTE: The default camera username is
admin
and the default
password is
admin
.
Accessing the Live Video Stream
Live video stream can be viewed using one of the following methods: