Connecting Peripheral Equipment
15
3. Attach the other end of the component cable (with the three BNC
connectors) to Component output of your video deck as follows:
a.
Connect the BNC attached to the green wire to the component
output connector labeled Y.
b.
Connect the BNC attached to the red wire to the component output
connector labeled R-Y.
c.
Connect the BNC attached to the blue wire to the component
output connector labeled B-Y.
4. Locate another component cable and attach the RCA and S-Video end
to the Avid Mojo DNA outputs as follows (see
):
a.
Connect the RCA connector to the yellow Composite video output
connector on the Avid Mojo DNA.
b.
Connect the S-Video connector to the S-Video output connector on
the Avid Mojo DNA.
5. Attach the other end of the component cable (with the three BNC
connectors) to Component input of your video deck as follows:
a.
Connect the BNC attached to the green wire to the component
input connector labeled Y.
b.
Connect the BNC attached to the red wire to the component input
connector labeled R-Y.
c.
Connect the BNC attached to the blue wire to the component input
connector labeled B-Y.
n
Make sure you terminate the input signal if your video deck supports
passthrough. See the documentation that is provided with your video deck.
Controlling a Video Deck
Avid editing systems provide video deck control through a serial control
connector on most decks. You can control a single deck by using an
RS-232 to RS-422 serial adapter. An optional RS-232 to RS-422 serial
adapter kit is available through Avid.
Summary of Contents for Mojo DNA
Page 28: ...Using the Avid Mojo DNA 28...
