Chapter 2: Installation and Setup
7
7
Plug one end of the Ethernet crossover cable into the Ethernet jack on the back panel of the Artist Transport.
8
Plug the other end of the Ethernet crossover cable into an available Ethernet jack on your computer, router, or Ethernet switch.
• Note that connecting directly to the computer may require removing your Internet cable. If you have a computer with two
Ethernet ports, use Ethernet 1, rather than Ethernet 2.
• An Ethernet router or switch is required to connect additional Artist Series media controllers, or to connect units to a local
area network.
9
Turn on your router (if applicable), then turn on your computer and wait until it finishes starting up.
Ethernet cable and rear panel jack
Artist Transport connected directly to a computer
Artist Mix and one Artist Transport connected to a computer through an Ethernet router (or switch)
SOLO
SOLO
ON
ON
SOLO
SOLO
ON
ON
SOLO
SOLO
ON
ON
SOLO
SOLO
ON
ON