AVG-UHD4K-44 V2
5.6 TCP/IP Control
5.6.1 Control Modes
TCP/IP default settings: IP is 192.168.0.178, Gateway is 192.168.0.1, and TCP Port
is 4001. The IP address can be changed as required, the TCP Port cannot be
changed.
Control via a single PC
Connect a computer to the TCP/IP port of the AVG-UHD4K-44 V2, and set its
network address in the same range as the default IP of the Matrix (192.168.0.178).
Set the Subnet mask to 255.255.255.0 and no gateway IP address is required.
Control by PC(s) in LAN
The AVG-UHD4K-44 V2 can be connected with a router to make up a LAN with the
PC(s), this allows it to be able to be controlled in a LAN. When controlling in this
manor, just make sure that the AVG-UHD4K-44 V2
’s network subnet is the same as
the routers. Please connect as per the following figure for LAN control.
Figure 5- 5 Connect to LAN
Step1.
Connect the TCP/IP port of the AVG-UHD4K-44 V2 to an Ethernet port of the
PC with twisted pair.
Step2.
Set the PC’s network subnet to the same as the Matrix Switcher. Please
remember the PC’s original network subnet setting.
Step3.
Set the AVG-UHD4K-44 V2
’s network subnet to the same as the router.
Step4.
Set the PC’s network subnet to the original setting.
Step5.
Connect the AVG-UHD4K-44 V2 and PC(s) to the router. In the same LAN,
each PC is able to control the AVG-UHD4K-44 V2 asynchronously.
Control is then possible via the TCP/IP communication software.
5.6.2 Control via TCP/IP communication software
1)
Connect a computer with TCP/UDP software to the AVG-UHD4K-44 V2. Open the
