AVGear AVG-MS44, User Manual

Page: 12 / 18

AVG-MS44
operation.
[x]All. Transfer signals from the
input channel [x] to all output
channels 1 To All.
All#. Transfer all input signals to
the corresponding output
channels respectively. All Through.
All$. Switch off all the output
channels. All Closed.
[x]#. Transfer signals from the
input channel [x] to the
output channel [x]. 1 Through.
[x]$. Switch off the output channel
[x]. 1 Closed.
[x]@. Switch on the output channel
[x]. 1 Open.
All@. Switch on all output
channels. All Open.
[x1] B[x2]. Transfer the AV signal from
the input channel [x1] to the
output channel [x2]. 01B02
Status[x]. Query [x] output statues. AV: 1-> 1
Status. Query all outputs statues
one by one. AV: 1-> 1 AV: 1-> 1 AV: 2->
2 AV: 3-> 3 AV: 4-> 4
Save[Y]. Save the present operation
to the preset command [Y],
ranges from 0 to 9. Save To F1
Recall[Y]. Recall the preset command
[Y]. Recall From F1
Clear[Y]. Clear the preset command
[Y]. Clear F1
PWON. Work in normal mode. PWON
PWOFF. Enter into standby mode. PWOFF
/%[Y]/[X]:[Z]. HDCP management
command. [Y] is for input
(value: I) or output (value:
O). [X] is the number of one
port, if the value of X is ALL,
it means all ports. [Z] is for
HDCP compliance status
(value: 1 or 0, 1 stands for
“with”, 0 stands for “without”).
Y=I & Z=1, means the
input port is compliant with
HDCP.
Y=O & Z=1, means output
with HDCP.
Y=I & Z=0, means the
input port is not
/%I/ALL:0.
compliant with HDCP.
Y=O & Z=0, means output without HDCP.