AVG AVG-TMX88PRO, Manual, Page: 27 / 41

AVG-TMX88PRO
Command Function
Feedback
Example
/%[Y]/[X]:[Z].
HDCP management command.
[Y] is for input (value: I) or output
(value: O); [X] is the number of the port,
if the value of X is ALL, it means all
ports; [Z] is for HDCP compliant status,
the value may be 1 (HDCP compliant)
or 0 (not HDCP compliant).
/%[Y]/[X]:[Z].
DigitAudioON[x].
Enable HDMI audio output of port x.
X=1, 2, 3, 4, 5, 6, 7, 8, enable this
port.
X=9, enable all the 8 ports.
DigitAudio ON with
[x]
DigitAudioOFF[x].
Disable HDMI audio output of port x.
X=1, 2, 3, 4, 5, 6, 7, 8, disable this port.
X=9, disable all the 8 ports.
DigitAudio OFF with
[x]
/+[Y]/[X]:******.
Set communication between PC and
HDBaseT Receiver.
①
Y is for RS232 port (connect with
RS232 port of HDBaseT Receiver)
a. Y = 1~8, send this command to the
corresponding HDBaseT Receiver
to control far-end device.
b. Y = 9, send this command to all
HDBaseT Receivers to control all
far-end devices.
c. Y = A~H, send this command to the
corresponding HDBaseT Receiver
connected to HDBT OUT 1~8 when
the switcher is power on
d. Y = I~P, send this command to the
corresponding HDBaseT Receiver
connected to HDBT OUT 1~8 when
the switcher is power off
②
X is for baud rate, its value ranges
from 1 to 7 (1--2400, 2--4800, 3--
9600, 4--19200, 5--38400, 6
—
57600, 7--115200)
①
***** is for data (max 48 Byte)
******
EDIDH[x]B[y].
Input port [y] learns the EDID from
output port [x].
If the EDID data is available and the
audio section supports not only PCM
mode, then force-set it to support PCM
mode only. If the EDID data is not
available, then set it to initial EDID
data.
EDIDH[x]B[y]
EDIDPCM[x].
Set the audio section of input port [x] to
PCM format in EDID database.
EDIDPCM[x]