10
ZP900 Post Scales User Instructions
Introduction
2.1 Unpacking and installation
Unpack the scale and check for any damage. Report damage to the shipping company
immediately.
2.1.1 Removing the shipping stops
Four colored shippings stops are installed under the platter of the BSQ scale at the
factory. Before you begin weighing be sure to remove these stops. Refer to the
following photos.
Repeat these steps on all four corners. Save and re-use if shipping the scale becomes
necessary in the future.
2.1.2 Leveling the scale
Place the scale on a level, stable surface free from vibrations or strong air currents.
Level the scale using adjustable feet and the bubble level located on the side of the
base. Turn the appropriate foot or feet until the bubble is centered and then lock the
feet in place by turning the locking collar snugly up against the scale body.
Figure 2.2 Foot and locking collar
Shipping stops shown taped in place.
Slide the stop down and
remove it from the slot. Keep
for future shipping.
Remove the tape and
slide the stop to the
nearest slot in the base
(pointed out in the photo
above).
Locking collar
Foot
