05/08 Rev. AB
OPERATOR’S HANDBOOK
Getting Started
9844/9854
1-16
Configuring the
Dispenser
Position
•
Application A:
The label is dispensed (peeled) so that a small portion still sticks to the
backing paper above the dispensing edge. After the dispensed label is
removed, the next label is immediately printed and dispensed.
«
Set
DISPENSER PARA > Dispenseposition
to –6.0 mm (set to –8.0 mm if the
material is very adhesive).
«
Set
DISPENSER PARA > Start Source
to
Light barrier.
•
Application B:
The printing and dispensing of the label is controlled by the optional foot
switch.
«
Set
SYSTEM PARAMETER > External Signal
to
Stacker full
.
«
Set
DISPENSER PARA > Dispenseposition
to –6.0 mm (set to –8.0 mm if the
material is very adhesive).
«
Set
DISPENSER PARA > Start Source
to
Foot switch.
Label length
< 40 mm
¯
If using very short labels (< 40 mm) set
PRINT PARAMETERS > Material length
< 40 mm (1.6 inches). The printer automatically initializes the material, which
improves the impression accuracy of the printout.
P
Refer to the “Info-Printouts and Parameters” section on your CD-ROM for
more information on parameter
DISPENSER PARA > Calibration mode
.
Offline Operation
Press the buttons indicated in black to perform the listed functions.
•
Switching from offline mode to online mode:
•
Switch to online mode when the print job is stopped:
•
Slow material and ribbon feed:
•
Material travels backwards under the printhead:
•
Reset:
OFFLINE x JOBS
ONLINE x JOBS
OFFLINE x JOBS
Stopped xx
ONLINE x JOBS
Stopped xx
OFFLINE x JOBS
OFFLINE x JOBS
feeding…
OFFLINE x JOBS
OFFLINE x JOBS
feeding…
OFFLINE x JOBS
OFFLINE x JOBS
Online
Online
Feed
Online
Cut
Online
Cut
Online
Feed
