Avery Dennison Monarch 9419, Manual

Page: 11 / 42

Loading Supplies 2-1
L O A D I N G S U P P L I E S
This chapter describes how to load:
♦
a roll of labels or tags
♦
peel mode supplies
♦
fan-fold supply.
Ask your System Administrator which type of supply to use:
Thermal Direct heat activated supplies that do not use a ribbon for printing.
Thermal Transfer standard supplies that require a ribbon for printing.
Note: When using thermal direct supplies, do not load a ribbon.
When using pre-printed supply or tinted supply, your System Administrator
should manually calibrate the sensor.
A d j u s t i n g t h e P l a t en R o l l e r
Adjust the platen roller based on supply
thickness. The default setting is for label supply.
Locate the platen roller tabs. Tabs are located on
either side of the platen roller.
Adjust both tabs
to the same position!
1.
Turn the cover latches and lift the cover.
2.
Press down and completely open the peel
door.
3. Pull on the platen roller tabs and rotate up to
unlock. Adjust as shown:
For l abel suppl i es l ess tha n
0. 007 i nche s (0. 1 9m m ) thi ck,
use thi s se tti ng.
For suppl i es 0. 007 i nche s
(0. 19m m ) thi ck or gr eat er,
use thi s se tti ng.
4.
Close the peel door.
5. Close the cover until you hear it click into place.
2
P eel Door